TKPRPGP comes up often in conversation and rarely with the context attached. Here we lay out the basics in order, then work through the practical considerations.
Last reviewed on 2026-08-01. Where a claim depends on a specific study, the study is described rather than over-claimed.
Selank is a synthetic heptapeptide with the sequence Thr-Lys-Pro-Arg-Pro-Gly-Pro, written TKPRPGP in one-letter notation. Its structure consists of the immunomodulatory tetrapeptide tuftsin, Thr-Lys-Pro-Arg, extended at the carboxyl terminus by a Pro-Gly-Pro segment. The molecular formula is commonly given as C33H57N11O9, corresponding to a monoisotopic mass near 751.4 Da and an average molecular mass near 751.9 Da. All seven residues are proteinogenic amino acids, and the molecule carries no modified side chains or non-natural linkages.
The compound was designed at the Institute of Molecular Genetics of the Russian Academy of Sciences during the 1980s and 1990s. The stated design goal was to retain the immunomodulatory and central nervous system activity attributed to tuftsin while improving resistance to enzymatic breakdown. Adding a proline-rich tail to the short parent peptide was a deliberate strategy, because proline residues restrict the conformations available to many peptidases. The same laboratory produced Semax, an ACTH fragment analog, and both compounds were developed in parallel as short, enzymatically stabilized peptides intended for intranasal use.
Characterization of Selank in laboratory settings relies on standard peptide analytical techniques. Reverse-phase high-performance liquid chromatography separates the peptide from related impurities and degradation products, while mass spectrometry confirms molecular identity through accurate mass measurement. Amino acid analysis and peptide sequencing verify the primary structure when reference material is unavailable. Because Selank is a short chain, fragmentation-based analysis produces a diagnostic ion pattern that supports confident identification.
Peptide stability depends strongly on temperature, moisture, and pH. Lyophilized Selank is generally most stable when stored cold and dry, with freezer temperatures commonly used for long-term storage. In solution, the compound is susceptible to hydrolysis and to microbial growth if it is not handled aseptically. The C-terminal proline-rich extension appears to slow enzymatic cleavage relative to tuftsin, though quantitative degradation rates vary with the matrix and the conditions tested. Published stability data specific to Selank remain sparse.
Quality assessment of Selank samples typically combines purity determination with identity confirmation and counter-ion analysis. Purity is usually reported as a percentage by chromatographic area, with values above 95 percent often quoted for research-grade material. Water content and residual solvents are checked in lyophilized batches because they affect both stability and accurate mass determination. A reported purity figure does not by itself establish that a sample is the intended sequence, so orthogonal methods are needed to rule out sequence isomers or truncation products.
| Property | Value | Notes |
|---|---|---|
| Peptide sequence | Thr-Lys-Pro-Arg-Pro-Gly-Pro | Seven residues; tuftsin plus a Pro-Gly-Pro tail |
| Molecular formula | C33H57N11O9 | Commonly reported value for the free peptide |
| Monoisotopic mass | Roughly 751.4 Da | Average molecular mass near 751.9 Da |
| Appearance | White to off-white powder | Typically supplied as a lyophilized solid |
| Solubility class | Freely soluble in water | Also dissolves in saline and other polar solvents |
Pharmacokinetic data are sparse and largely derived from animal work. After intranasal administration the peptide appears in plasma within minutes, and reported half-lives are short, on the order of minutes to tens of minutes. Degradation proceeds through ordinary proteolytic cleavage into constituent amino acids and smaller fragments. Direct evidence that intact Selank reaches brain tissue in meaningful amounts is limited, and the extent of blood-brain barrier penetration is debated. Some authors argue that fragments, not the parent peptide, carry much of the observed activity.
Published clinical work is concentrated in Russian-language journals and generally involves small samples without independent replication. Systematic reviews in English note the shortage of randomised, placebo-controlled trials and the difficulty of verifying methods from translated reports. Outcome measures vary between studies, which complicates pooling of results. Interest in the compound as a cognitive or anxiolytic agent therefore rests on a thinner evidence base than the volume of citations suggests. Replication in well-powered trials with preregistered endpoints would be needed before firm conclusions about efficacy can be drawn.
Quantification in biological matrices relies on liquid chromatography coupled to tandem mass spectrometry with stable-isotope internal standards. Low plasma concentrations and adsorption to container surfaces both complicate measurement. Solid-phase extraction is often needed to reduce matrix interference before injection. Reported limits of quantification differ widely between laboratories, which makes direct comparison of pharmacokinetic results difficult and limits meta-analysis.
Peptide bonds are vulnerable to protease attack, and Selank is no exception. Measured half-life in serum is short, on the order of minutes in several reports, which explains why intranasal administration is the common route described in the literature. Absorption across the nasal mucosa partially bypasses first-pass hepatic metabolism. Quantitative data on human bioavailability remain limited and are difficult to compare across studies.
Lyophilised material kept dry at minus 20 degrees Celsius or colder is the most stable form, and suppliers commonly state a shelf life of two years or more under those conditions. Once dissolved, degradation accelerates through hydrolysis and deamidation, particularly at alkaline pH or elevated temperature. Working solutions are usually divided into single-use aliquots to avoid repeated freeze-thaw cycles. The choice of reconstitution solvent affects both stability and the ionic strength of the final preparation.
Naming for this compound is not fully standardised in English sources. The spelling Selanc appears in some transliterations, and catalogue entries may instead list the peptide sequence itself as the identifier. Reference material sometimes groups it with other short synthetic peptides studied for behavioural effects, which can create confusion when citations are compared. Distinguishing the exact sequence from related tuftsin analogues is therefore a practical first step when reviewing any dataset or specification sheet.
Selank is a synthetic heptapeptide with the sequence Thr-Lys-Pro-Arg-Pro-Gly-Pro, frequently abbreviated as TKPRPGP. It was designed as a structural analogue of tuftsin, a naturally occurring tetrapeptide released by enzymatic cleavage of the immunoglobulin heavy chain. The two additional proline residues at the C-terminal end extend the parent chain and change how the molecule behaves in solution. The free peptide has a calculated molecular mass of approximately 751.9 g/mol and is generally supplied as a lyophilised white to off-white powder.
Regulatory treatment varies by jurisdiction. In Russia the compound is a registered prescription product, while in the European Union and the United States it is generally handled as a research chemical without a marketing authorization. Suppliers therefore operate outside pharmaceutical oversight, and buyers rely on supplier documentation for purity and identity claims. Chain of custody and third-party testing are the main verification tools. Analysts note that the absence of a pharmacopoeial monograph for research-grade material limits standardization across vendors.
Purity assessment relies mainly on reverse-phase high-performance liquid chromatography with ultraviolet detection. Because the peptide lacks a strong chromophore, detection often uses backbone absorbance near 214 nm. Identity is confirmed by mass spectrometry, typically electrospray ionization or matrix-assisted laser desorption, comparing the measured mass against the expected value. Amino acid analysis can verify composition after acid hydrolysis. Diastereomer content and residual counterions are reported less often, although both can influence biological assays.
Lyophilized material is generally stable for extended periods when kept dry at or below minus twenty degrees Celsius. Working solutions are less stable, and common practice is to aliquot and freeze them so that repeated freeze-thaw cycles are avoided. Aqueous solutions are sensitive to pH extremes and to microbial growth, so short-term storage at refrigerator temperature is typical. Oxidation and hydrolysis are the principal degradation routes. Reconstitution with sterile water or a mild buffer is standard, and solutions should be protected from light.
Chemical potential is the partial molar free energy. The potential, μi, of the ith species in a chemical reaction is the partial derivative of the free energy with respect to the number of moles of that species, Ni:
The concentration of secondary metabolites such as phenylpropanoids and flavonoids can also be altered in plants exposed to high concentrations of CO2. Plants also emit CO2 during respiration, and so the majority of plants and algae, which use C3 photosynthesis, are only net absorbers during the day. Though a growing forest will absorb many tons of CO2 each year, a mature forest will produce as much CO2 from respiration and decomposition of dead specimens (e.g., fallen branches) as is used in photosynthesis in growing plants. Contrary to the long-standing view that they are carbon neutral, mature forests can continue to accumulate carbon and remain valuable carbon sinks, helping to maintain the carbon balance of Earth's atmosphere. Additionally, and crucially to life on earth, photosynthesis by phytoplankton consumes dissolved CO2 in the upper ocean and thereby promotes the absorption of CO2 from the atmosphere.
== Smart insulin pen compatibility == A smart insulin pen is a reusable injector pen designed to assist people with diabetes in managing insulin delivery more effectively. This system is paired with a smartphone app that calculates and tracks insulin doses, providing reminders, alerts, and reports to ensure better diabetes management. Some smart insulin pens are capable of integrating with Dexcom continuous glucose monitoring data, enabling users to make more informed decisions based on real-time glucose levels. These pens can be either an add-on to an existing insulin pen or a standalone reusable device that uses prefilled cartridges instead of vials or disposable pens.
Sources: en.wikipedia.org
Multiple factors can trigger HHS, including infection, myocardial infarction, and trauma, as well as infections in the respiratory, digestive, and urinary systems. Rising obesity rates and the greater consumption of high-carbohydrate beverages have both played a role in the increased incidence of HHS. Moreover, certain medications prescribed for different conditions have the potential to cause HHS. As with DKA, urgent medical treatment is necessary, commonly beginning with fluid volume replacement. On the whole, HHS is a medical emergency marked with hyperglycemia, hyperosmolarity, dehydration, and mild or no ketosis.
=== Biochemistry and biomedical uses === Sodium azide is a useful probe reagent, and an antibacterial preservative for biochemical solutions. In the past merthiolate and chlorobutanol were also used as an alternative to azide for preservation of biochemical solutions. Sodium azide is an instantaneous inhibitor of lactoperoxidase, which can be useful to stop lactroperoxidase catalyzed 125I protein radiolabeling experiments. In hospitals and laboratories, it is a biocide; it is especially important in bulk reagents and stock solutions which may otherwise support bacterial growth where the sodium azide acts as a bacteriostatic by inhibiting cytochrome oxidase in gram-negative bacteria; however, some gram-positive bacteria (streptococci, pneumococci, lactobacilli) are intrinsically resistant.
First MD simulation of a simplified biological folding process was published in 1975. Its simulation published in Nature paved the way for the vast area of modern computational protein-folding. First MD simulation of a biological process was published in 1976. Its simulation published in Nature paved the way for understanding protein motion as essential in function and not just accessory. MD is the standard method to treat collision cascades in the heat spike regime, i.e., the effects that energetic neutron and ion irradiation have on solids and solid surfaces. The following biophysical examples illustrate notable efforts to produce simulations of a systems of very large size (a complete virus) or very long simulation times (up to 1.112 milliseconds):
Serbian police and VJ units attacked KLA outposts, attempting to destroy them, as KLA units attempted to avoid direct confrontation and use terrorist attacks, including bombings and ambushes, to weaken Yugoslav control. Although unable to gain a strategic advantage, Yugoslav Army units found themselves in a tactical advantage against KLA units which lacked proper training. VJ units themselves lacked morale, and attacks were often directed against civilian targets rather than military targets. 863,000 Albanian civilians were forcibly expelled between March and June 1999 from Kosovo. 169,824 Serb and Romani civilians were estimated by the UNHCR's Belgrade office to have fled from Kosovo-Metohija to either Serbia proper, the Autonomous Province of Vojvodina, or the constituent Republic of Montenegro by 20 June 1999. Out of 10,317 civilians, 8,676 Albanians, 1,196 Serbs and 445 Roma, Bosniaks, Montenegrins and others were killed or went missing in connection with the war between 1 January 1998 - 31 December 2000. The Serbian government attributed 1,953 Serbian, 361 Albanian and 266 other civilian deaths or disappearances from 1 January 1998 - 1 November 2001 to "Albanian terrorism in Kosovo-Metohija". The international community was quick to respond, issuing a peace proposal to Yugoslavia in 1999. The agreement was seen as essentially an ultimatum by NATO to Yugoslavia, and this was rejected by the Yugoslav government.
Sources: en.wikipedia.org
The sequence is Thr-Lys-Pro-Arg-Pro-Gly-Pro, written TKPRPGP in one-letter code. It combines the tetrapeptide tuftsin with a carboxyl-terminal Pro-Gly-Pro extension. This full sequence identifies the molecule more precisely than the research name.
No peptide with this exact sequence has been identified as an endogenous substance. It is a laboratory-designed analog of tuftsin, a naturally occurring immunomodulatory tetrapeptide. The Pro-Gly-Pro extension has no known natural source.
Proline introduces conformational constraints that make a peptide less accessible to common peptidases. This is a standard stabilization strategy in peptide design. The added residues also increase the distance between the active tuftsin portion and typical cleavage sites.
The most common approach combines reverse-phase liquid chromatography with mass spectrometry. Chromatography separates the components while mass spectrometry confirms the molecular mass. Peptide sequencing or tandem mass analysis can further verify the amino acid order.