lyophilised powder is one of those subjects where the details matter more than the headlines. This page pulls together the background, the mechanisms, and the practical points readers ask about most.
Updated 2025-12-28. Numbers and descriptions here follow the published literature rather than marketing material.
Outside its country of origin the compound is generally handled as a research chemical rather than an approved medicine. No regulatory approval from the United States Food and Drug Administration or the European Medicines Agency has been granted for human use. Identity and purity are normally checked by reverse-phase high-performance liquid chromatography, with mass spectrometry used to confirm the molecular mass. Lyophilised material is stored cold and desiccated, and repeated freeze-thaw cycles are avoided.
Published work on this peptide almost always uses intranasal delivery, with drops or a spray applied to the nasal mucosa. Some animal experiments have used subcutaneous or intraperitoneal injection, and a smaller number have compared routes directly. Oral administration is not a focus of the literature, because short peptides of this size are broken down by digestive enzymes and cross intestinal barriers poorly. How much of an intranasal dose reaches the bloodstream intact in humans remains an open question.
Peptide stability depends strongly on temperature, moisture, and pH. Lyophilized Selank is generally most stable when stored cold and dry, with freezer temperatures commonly used for long-term storage. In solution, the compound is susceptible to hydrolysis and to microbial growth if it is not handled aseptically. The C-terminal proline-rich extension appears to slow enzymatic cleavage relative to tuftsin, though quantitative degradation rates vary with the matrix and the conditions tested. Published stability data specific to Selank remain sparse.
Quality assessment of Selank samples typically combines purity determination with identity confirmation and counter-ion analysis. Purity is usually reported as a percentage by chromatographic area, with values above 95 percent often quoted for research-grade material. Water content and residual solvents are checked in lyophilized batches because they affect both stability and accurate mass determination. A reported purity figure does not by itself establish that a sample is the intended sequence, so orthogonal methods are needed to rule out sequence isomers or truncation products.
| Property | Value | Notes |
|---|---|---|
| Common route | Intranasal | Also injected in some animal work |
| Solubility class | Freely soluble in water | Solid form is hygroscopic |
| Typical storage | About -20 degrees Celsius | Keep desiccated and dark |
| Purity method | Reverse-phase HPLC | Reported as area percent |
| Confirmatory method | Mass spectrometry | Verifies expected molecular mass |
Reverse-phase high-performance liquid chromatography with ultraviolet detection near 214 nanometres is the standard purity method. Mass spectrometry, typically electrospray ionisation, confirms identity through the expected mass-to-charge pattern. Amino acid analysis can verify composition independently. Chiral purity requires separate techniques such as derivatisation followed by chromatographic separation, and such data are rarely reported for research-grade material.
Quantification in biological matrices relies on liquid chromatography coupled to tandem mass spectrometry with stable-isotope internal standards. Low plasma concentrations and adsorption to container surfaces both complicate measurement. Solid-phase extraction is often needed to reduce matrix interference before injection. Reported limits of quantification differ widely between laboratories, which makes direct comparison of pharmacokinetic results difficult and limits meta-analysis.
Lyophilized material is generally stable for extended periods when kept dry at or below minus twenty degrees Celsius. Working solutions are less stable, and common practice is to aliquot and freeze them so that repeated freeze-thaw cycles are avoided. Aqueous solutions are sensitive to pH extremes and to microbial growth, so short-term storage at refrigerator temperature is typical. Oxidation and hydrolysis are the principal degradation routes. Reconstitution with sterile water or a mild buffer is standard, and solutions should be protected from light.
Regulatory treatment varies by jurisdiction. In Russia the compound is a registered prescription product, while in the European Union and the United States it is generally handled as a research chemical without a marketing authorization. Suppliers therefore operate outside pharmaceutical oversight, and buyers rely on supplier documentation for purity and identity claims. Chain of custody and third-party testing are the main verification tools. Analysts note that the absence of a pharmacopoeial monograph for research-grade material limits standardization across vendors.
Selank is a synthetic heptapeptide with the sequence Thr-Lys-Pro-Arg-Pro-Gly-Pro. Its four N-terminal residues reproduce tuftsin, a tetrapeptide fragment of the immunoglobulin heavy chain, while the C-terminal Pro-Gly-Pro extension is a synthetic addition. The peptide has a molecular mass near 752 daltons and carries a net positive charge at physiological pH because of the arginine and lysine side chains. Published indexes list it under the name Selank and the sequence abbreviation TKPRPGP. Solid-phase peptide synthesis is the standard production route for research quantities.
Development took place at the Institute of Molecular Genetics of the Russian Academy of Sciences, where a series of short peptides were designed in the 1980s and 1990s. Selank was selected from variants of tuftsin that showed resistance to plasma peptidases. Russian regulatory approval covers it as an anxiolytic agent given intranasally. Outside that market the compound is normally handled as a research chemical rather than a medicine, and no widely recognised international pharmacopoeial monograph exists. The name Selank is a coined trade designation rather than a systematic chemical name.
Peptide bonds in selank are susceptible to hydrolysis under strongly acidic or basic conditions, and the terminal proline residues are vulnerable to exopeptidase activity in biological samples. Lyophilized powder stored dry at -20 °C typically remains stable for extended periods, whereas aqueous solutions degrade faster and may lose measurable purity within days to weeks depending on pH, temperature, and microbial load. Repeated freeze-thaw cycles promote aggregation and adsorption to container surfaces. For analytical work, solutions are usually prepared fresh, kept cold, and used within a single working day.
Handling follows standard practice for research peptides. Material is weighed in a low-humidity environment because the powder absorbs atmospheric moisture. Purity is reported as the percentage area of the main peak in a chromatogram, with specifications commonly set at 95 percent or higher; values below that threshold indicate the presence of truncated or modified species. Residual trifluoroacetate from purification is often present and may affect mass balance. Certificates of analysis should state the analytical method, the column and gradient used, and the lot-specific retention time so that results can be compared across suppliers.
Identity and purity of selank are established with reversed-phase high-performance liquid chromatography coupled to mass spectrometry. The peptide elutes from C18 columns with acetonitrile gradients in water containing trifluoroacetic acid or formic acid, and detection is usually performed by ultraviolet absorbance near 214 nm. Electrospray ionization in positive mode gives a doubly protonated ion near m/z 377, consistent with a mass of about 752 Da. Amino acid analysis or tandem mass spectrometry of fragment ions confirms the sequence. Because the molecule has no aromatic residues, it lacks a usable 280 nm chromophore, so low-wavelength detection or mass spectrometry is required.
He is currently incarcerated in the maximum security prison of Vught, and he is the main suspect in the current marengo trial, which is considered to be the largest criminal trial in Dutch history. He is facing life of imprisonment without the possibility of parole. The former president of Suriname, Dési Bouterse, is faced with corruption charges after cooperating with Taghi and his left hand man Mao R.
== ABRF Award == The ABRF Award is presented at the annual ABRF meeting for outstanding contributions to Biomolecular Technologies. Past Award Winners (the years refer to the annual conference at which the award was presented):
==== France ==== In France, most preparations containing codeine only began requiring a doctor's prescription in 2017. Products containing codeine include Néocodion (codeine and camphor), Tussipax (ethylmorphine and codeine), Paderyl (codeine alone), Codoliprane (codeine with paracetamol), Prontalgine and Migralgine (codeine, paracetamol and caffeine). The 2017 law change made a prescription mandatory for all codeine products, along with those containing ethylmorphine and dextromethorphan.
== History == The new drug application for Vicoprofen was approved based on data from both single and multiple dose analgesia trials. The single dose analgesia studies occurred in multiple surgical settings, including dental, back, and abdominal/gynecologic surgery in the US and Puerto Rico. There were 1,537 patients enrolled over all trials, with 79% of the participants being female. There were 10 single dose analgesia trials included in the new drug application. All studies were similarly designed: after completion of a procedure in which pain was rated as moderate or severe, patients would be randomized into various treatment groups. The treatment groups included: ibuprofen only, hydrocodone only, Vicoprofen (hydrocodone/ibuprofen), and placebo. The participant's pain would then be tracked over the next several hours by the self reporting of pain scores. There were four multiple dose trials included in the new drug application. These studies were all completed in the US, in settings including burn unit, post-operatively, and chronic pain settings. A total of 683 patients were enrolled in all of the multiple dose trials, with 57% of the participants being women. These studies also looked at self reported pain intensities over a 5-day period of multiple dosing. In these studies, patients were either given the trial drug Vicoprofen or one of two an active controls: codeine with acetaminophen (Tylenol #3) or oxycodone with acetaminophen (Percocet), depending on the trial. Patients were allowed to take a dose as needed but no more than every 4 to 6 hours for up to 5 days.
Sources: en.wikipedia.org
=== Location === The SA node is located in the wall (epicardium) of the right atrium, laterally to the entrance of the superior vena cava in a region called the sinus venarum (hence sino- + atrial). It is positioned roughly between a groove called the crista terminalis located on the internal surface of the heart and the corresponding sulcus terminalis, on the external surface. These grooves run between the entrance of the superior vena cava and the inferior vena cava.
On Czapek Yeast Extract Agar medium at 25 °C, white colonies grow in a plane, attaining a velvety to deeply floccose texture, with colony sizes that are 33–35 mm in diameter. On this medium, olive conidia are produced. The reverse of the plate can be pale or slightly tinted brown. On Malt Extract Agar medium at 25 °C, growth is rare, yet rapid when occurring, forming a velvety surface. At first, colonies are yellow-green, but ultimately turn olive due to conidial production. Colony diameter can range in size from 35 mm to 70 mm. The reverse of the plate is similar to that observed for Czapek Yeast Extract Agar medium. On 25% Glycerol Nitrate Agar at 25 °C, colony growth is planar, yet develops into a thick gel, with colony size diameter ranging from 6–12 mm. The back of the plate is described as pale or olive. At 5 °C, 25% Glycerol Nitrate Agar supports germination and a colonial growth of up to 3 mm in diameter. This species fails to grow at 37 °C. On Creatine Sucrose Agar at 25 °C, colony size diameter ranges from 4 to 10 mm. Growth is restricted, and medium pH remains around 7. No change on the back of the plate is noted. Growth on media containing orange fruit pieces for seven days at room temperature results in fruit decay, accompanied by a characteristic odour. After 14 days at room temperature, the reverse is colourless to light brown.
==== Antiquity ==== Yavne was one of the major ancient cities in the southern coastal plain, situated 20 km (12.43 mi) south of Jaffa, 15 km (9.32 mi) north of Ashdod, and 7 km (4.35 mi) east of the Mediterranean. From excavations of the ancient tell (mound created by accumulation of archaeological remains) known as Tel Yavne (Hebrew), which developed on a natural kurkar hill, the area shows to have been inhabited continuously from either the Bronze or Iron Age until the British Mandate. During some periods, especially the Byzantine period, the settlement expanded to cover part of the plain and hills surrounding the tell. Yavne is mentioned in the Bible and other ancient texts. In Roman times, the city was known as Iamnia or Jamnia. It was bequeathed by King Herod upon his death to his sister Salome. Upon her death it passed to Emperor Augustus, who ran it as a private imperial estate, a status retained for at least a century. After Salome's death, Iamnia came into the property of Livia, the future Roman empress, and then to her son Tiberius. In the 40s AD, a dispute emerged in Jamnia when Gentiles constructed a mud-brick altar to the Emperor, provoking the local Jewish population. The Jews destroyed the altar, which they saw as desecration. This led the Gentiles to complain to Capito, the imperial revenue collector in Judaea, who reported the matter to Emperor Caligula. In retaliation, Caligula ordered a statue of himself as Jupiter to be placed in the Holy of Holies at the Temple of Jerusalem. Iamnia played a role in several events during the First Jewish–Roman War.
Phenylglyoxal is the organic compound with the formula C6H5C(O)C(O)H. It contains both an aldehyde and a ketone functional group. It is yellow liquid when anhydrous but readily forms a colorless crystalline hydrate. It has been used as a reagent to modify the amino acid, arginine. It has also been used to attach chemical payload (probes) to the amino acid citrulline and to peptides/proteins.
The survival of Franz Joseph was also commemorated in Prague by erecting a new statue of St. Francis of Assisi, the patron saint of the emperor, on Charles Bridge. It was donated by Count Franz Anton von Kolowrat-Liebsteinsky, the first minister-president of the Austrian Empire.
Sources: en.wikipedia.org
Most published work uses intranasal application, either as drops or as a nasal spray. Injection routes appear in a smaller set of animal experiments. Oral use is uncommon in the literature because peptide breakdown and poor absorption limit this route.
Reported human trials are few, brief and originate mainly from one country. They describe effects on anxiety-related measures, but sample sizes are small and reporting is limited. The results are widely regarded as preliminary rather than confirmed.
Reverse-phase liquid chromatography is used to assess purity and separation of related impurities. Mass spectrometry confirms that the observed molecular mass matches the expected peptide. A certificate of analysis from the supplier is the usual document of record.
The most common approach combines reverse-phase liquid chromatography with mass spectrometry. Chromatography separates the components while mass spectrometry confirms the molecular mass. Peptide sequencing or tandem mass analysis can further verify the amino acid order.