The short version of heptapeptide fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2026-05-29 and is reviewed periodically as new material appears.
Peptide bonds are vulnerable to protease attack, and Selank is no exception. Measured half-life in serum is short, on the order of minutes in several reports, which explains why intranasal administration is the common route described in the literature. Absorption across the nasal mucosa partially bypasses first-pass hepatic metabolism. Quantitative data on human bioavailability remain limited and are difficult to compare across studies.
Lyophilised material kept dry at minus 20 degrees Celsius or colder is the most stable form, and suppliers commonly state a shelf life of two years or more under those conditions. Once dissolved, degradation accelerates through hydrolysis and deamidation, particularly at alkaline pH or elevated temperature. Working solutions are usually divided into single-use aliquots to avoid repeated freeze-thaw cycles. The choice of reconstitution solvent affects both stability and the ionic strength of the final preparation.
Regulatory treatment varies by jurisdiction. In Russia the compound is a registered prescription product, while in the European Union and the United States it is generally handled as a research chemical without a marketing authorization. Suppliers therefore operate outside pharmaceutical oversight, and buyers rely on supplier documentation for purity and identity claims. Chain of custody and third-party testing are the main verification tools. Analysts note that the absence of a pharmacopoeial monograph for research-grade material limits standardization across vendors.
Purity assessment relies mainly on reverse-phase high-performance liquid chromatography with ultraviolet detection. Because the peptide lacks a strong chromophore, detection often uses backbone absorbance near 214 nm. Identity is confirmed by mass spectrometry, typically electrospray ionization or matrix-assisted laser desorption, comparing the measured mass against the expected value. Amino acid analysis can verify composition after acid hydrolysis. Diastereomer content and residual counterions are reported less often, although both can influence biological assays.
Lyophilized material is generally stable for extended periods when kept dry at or below minus twenty degrees Celsius. Working solutions are less stable, and common practice is to aliquot and freeze them so that repeated freeze-thaw cycles are avoided. Aqueous solutions are sensitive to pH extremes and to microbial growth, so short-term storage at refrigerator temperature is typical. Oxidation and hydrolysis are the principal degradation routes. Reconstitution with sterile water or a mild buffer is standard, and solutions should be protected from light.
| Property | Value | Notes |
|---|---|---|
| Dry storage temperature | -20 C or below | Sealed, desiccated, protected from light |
| Solution stability | Hours to days at 2-8 C | Depends on buffer and microbial load |
| Preferred pH range | Near neutral to slightly acidic | Alkaline pH accelerates hydrolysis |
| Main degradation routes | Hydrolysis and deamidation | No cysteine or methionine in sequence |
| Identity confirmation | Electrospray mass spectrometry | Observed mass compared with 751.9 Da |
Development took place at the Institute of Molecular Genetics of the Russian Academy of Sciences, where a series of short peptides were designed in the 1980s and 1990s. Selank was selected from variants of tuftsin that showed resistance to plasma peptidases. Russian regulatory approval covers it as an anxiolytic agent given intranasally. Outside that market the compound is normally handled as a research chemical rather than a medicine, and no widely recognised international pharmacopoeial monograph exists. The name Selank is a coined trade designation rather than a systematic chemical name.
Enzymatic stability motivates the extra three residues at the carboxyl end. Native tuftsin is cleaved quickly by circulating aminopeptidases and carboxypeptidases, which limits its duration of action and its usefulness as a tool compound. Extending the chain with proline-rich segments is a common design tactic because proline constrains the backbone and slows proteolysis. The same Pro-Gly-Pro motif appears in other Russian-developed peptides of the era. Whether the full seven-residue chain is required for activity, or whether it acts mainly as a prodrug releasing tuftsin, remains unresolved.
Handling follows standard practice for research peptides. Material is weighed in a low-humidity environment because the powder absorbs atmospheric moisture. Purity is reported as the percentage area of the main peak in a chromatogram, with specifications commonly set at 95 percent or higher; values below that threshold indicate the presence of truncated or modified species. Residual trifluoroacetate from purification is often present and may affect mass balance. Certificates of analysis should state the analytical method, the column and gradient used, and the lot-specific retention time so that results can be compared across suppliers.
Identity and purity of selank are established with reversed-phase high-performance liquid chromatography coupled to mass spectrometry. The peptide elutes from C18 columns with acetonitrile gradients in water containing trifluoroacetic acid or formic acid, and detection is usually performed by ultraviolet absorbance near 214 nm. Electrospray ionization in positive mode gives a doubly protonated ion near m/z 377, consistent with a mass of about 752 Da. Amino acid analysis or tandem mass spectrometry of fragment ions confirms the sequence. Because the molecule has no aromatic residues, it lacks a usable 280 nm chromophore, so low-wavelength detection or mass spectrometry is required.
An alpha helix (or α-helix) is a sequence of amino acids in a protein that are twisted into a coil (a helix). The alpha helix is the most common structural arrangement in the secondary structure of proteins. It is also the most extreme type of local structure, and it is the local structure that is most easily predicted from a sequence of amino acids. The alpha helix has a right-handed helix conformation in which every backbone N−H group hydrogen bonds to the backbone C=O group of the amino acid that is four residues earlier in the protein sequence. The alpha helix is also commonly called a: Pauling–Corey–Branson α-helix (from the names of three scientists who described its structure) 3.613-helix because there are 3.6 amino acids in one ring, with 13 atoms being involved in the ring formed by the hydrogen bond (starting with amidic hydrogen and ending with carbonyl oxygen)
The classic Monod–Wyman–Changeux model (MWC) for cooperativity is generally published in an irreversible form. That is, there are no product terms in the rate equation which can be problematic for those wishing to build metabolic models since there are no product inhibition terms. However, a series of publications by Popova and Sel'kov derived the MWC rate equation for the reversible, multi-substrate, multi-product reaction. The same problem applies to the classic Hill equation which is almost always shown in an irreversible form. Hofmeyr and Cornish-Bowden first published the reversible form of the Hill equation. The equation has since been discussed elsewhere and the model has also been used in a number of kinetic models such as a model of Phosphofructokinase and Glycolytic Oscillations in the Pancreatic β-cells or a model of a glucose-xylose co-utilizing S. cerevisiae strain. The model has also been discussed in modern enzyme kinetics textbooks.
Technetium, with atomic number Z = 43, is the lowest-numbered element in the periodic table for which all isotopes are radioactive. The second-lightest exclusively radioactive element, promethium, has atomic number 61. Atomic nuclei with an odd number of protons are less stable than those with even numbers, even when the total number of nucleons (protons + neutrons) is even, and odd numbered elements have fewer stable isotopes. The most stable radioactive isotopes are technetium-97 with a half-life of 4.21±0.16 million years and technetium-98 with 4.2±0.3 million years; current measurements of their half-lives give overlapping confidence intervals corresponding to one standard deviation and therefore do not allow a definite assignment of technetium's most stable isotope. The next most stable isotope is technetium-99, which has a half-life of 211,100 years. Thirty-four other radioisotopes have been characterized with mass numbers ranging from 86 to 122. Most of these have half-lives that are less than an hour, the exceptions being technetium-93 (2.75 hours), technetium-94 (4.88 hours), technetium-95 (19.26 hours), and technetium-96 (4.28 days). The primary decay mode for isotopes lighter than technetium-98 (98Tc) is electron capture, producing molybdenum (Z = 42). For technetium-98 and heavier isotopes, the primary mode is beta emission (the emission of an electron or positron), producing ruthenium (Z = 44), with the exception that technetium-98 and technetium-100 can decay both by beta emission and electron capture.
== History == Precursor drugs to repaglinide were invented in late 1983 by scientists at Dr Karl Thomae GmbH, a German drug manufacturer located at Biberach an der Riß in southern Germany which was acquired by Boehringer Ingelheim in 1990. The drug that became repaglinide was later licensed by Boehringer to Novo Nordisk, which filed an Investigational New Drug application for the compound with the Food and Drug Administration (FDA) in April 1992. Novo Nordisk filed its New Drug Application (NDA) for Prandin in July 1997 and it was quickly approved, gaining FDA approval in December 1997. The drug was the first of the meglitinide class. It was branded Prandin because its quick onset and short duration of action concentrates its effect around meal time (the prandium was the Roman meal which is comparable to the modern lunch).
On 26 August 2008, Financial Times wrote that "Most accounts agree that it was South Ossetian separatists who committed the first act of escalation when they blew up a Georgian military vehicle on August 1, wounding five Georgian peacekeeping troops." It argued: "So swift was the Russian reaction that some analysts believe that, while it did not appear to precede the Georgian assault on Tskhinvali, as Mr Saakashvili claims, it may have been planned in advance, with Mr Saakashvili simply falling into a well prepared Russian trap."
Sources: en.wikipedia.org
Six different types of vancomycin resistance are shown by enterococcus: Van-A, Van-B, Van-C, Van-D, Van-E and Van-G. The significance is that Van-A VRE is resistant to both vancomycin and teicoplanin, Van-B VRE is resistant to vancomycin but susceptible to teicoplanin, and Van-C is only partly resistant to vancomycin. The mechanism of resistance to vancomycin found in Enterococcus involves the alteration of the peptidoglycan synthesis pathway. The D-alanyl-D-lactate variation results in the loss of one hydrogen-bonding interaction (four, as opposed to five for D-alanyl-D-alanine) being possible between vancomycin and the peptide. The D-alanyl-D-serine variation causes a six-fold loss of affinity between vancomycin and the peptide, likely due to steric hindrance.
Glucose is an energy source in most life forms. For instance, polysaccharides are broken down into their monomers by enzymes (glycogen phosphorylase removes glucose residues from glycogen, a polysaccharide). Disaccharides like lactose or sucrose are cleaved into their two component monosaccharides.
== Overdose == In high doses, overdoses, or in some persons not tolerant to opioids, oxycodone can cause shallow breathing, slowed heart rate, cold/clammy skin, pauses in breathing, low blood pressure, constricted pupils, circulatory collapse, respiratory arrest, and death. In 2011, it was the leading cause of drug-related deaths in the U.S. However, from 2012 onwards, heroin and fentanyl have become more common causes of drug-related deaths.
=== Role in aging === The relationship between RAGE signaling and aging has been a growing focus of research, particularly in the context of cellular senescence and inflammaging—chronic, low-grade inflammation associated with aging. RAGE has been implicated in promoting cellular senescence, a permanent state of cell-cycle arrest, which contributes to the accumulation of dysfunctional cells that secrete pro-inflammatory factors, collectively referred to as the senescence-associated secretory phenotype (SASP). A study conducted in 2022 demonstrated that the activation of RAGE by AGEs in aged tissues leads to the accumulation of senescent cells, thereby exacerbating tissue inflammation and contributing to age-related diseases. This study also noted that the upregulation of RAGE in aged cells increased the secretion of SASP factors, such as interleukin-6 (IL-6) and tumor necrosis factor-alpha (TNF-α), both of which are key mediators of inflammaging. Another recent investigation from 2023 found that mice deficient in RAGE exhibited reduced markers of senescence and systemic inflammation compared to age-matched controls, suggesting that targeting RAGE signaling may be a promising approach to mitigate the adverse effects of aging and extend healthspan. These findings highlight the role of RAGE as a crucial regulator of the inflammatory milieu associated with aging, providing potential avenues for therapeutic interventions aimed at reducing age-related inflammatory diseases.
Sources: en.wikipedia.org
Dry powder is best kept sealed, protected from light, and held at minus 20 degrees Celsius or below. Desiccant packaging helps limit moisture uptake because the material is hygroscopic. A sealed vial should be allowed to equilibrate to room temperature before opening to reduce condensation.
Hydrolysis of peptide bonds and deamidation of arginine and proline residues are the main degradation routes. Alkaline pH and higher temperatures accelerate both processes. Buffered, near-neutral solutions stored cold generally degrade more slowly than unbuffered ones.
Reverse-phase chromatography gives the clearest single view of related impurities and truncated sequences. Mass spectrometry then confirms that the main peak carries the expected mass. Neither test detects enantiomeric impurities, which require a separate chiral assay.
Purity is usually reported as an HPLC area percentage, most often measured at 214 nm. Identity is confirmed separately by mass spectrometry. A certificate of analysis should state both the method and the observed value.