A practical reference on Semax: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
This page was last updated on 2025-11-18 and is reviewed periodically as new material appears.
Once dissolved, the peptide is markedly less stable than the dry powder. Aqueous solutions are subject to backbone hydrolysis and to microbial growth when they are handled without sterile technique. Buffered solutions near neutral pH are common for short-term laboratory work, while acidic conditions are sometimes used to improve solubility. Analytical laboratories generally prepare working solutions fresh rather than storing them, and a residual water film left in a reopened vial can seed degradation even when the container appears dry.
Reversed-phase high-performance liquid chromatography is the standard technique for estimating peptide purity. The result is a peak-area percentage, which describes how much of the detected material elutes as the main peak in one run. Mass spectrometry confirms the molecular mass and can reveal truncated, adducted, or otherwise modified species. Amino acid analysis or tandem mass spectrometry can address sequence fidelity when identity is in doubt. None of these measurements, taken alone, establishes that a sample is fit for any specific purpose.
Lyophilized selank is normally supplied as a dry powder and is considered stable for extended periods when kept cold and dry. Moisture uptake is the main practical threat, because absorbed water promotes both hydrolysis and aggregation in the solid state. Vials are usually warmed to room temperature before opening so that condensation does not form on the powder. Supplier documentation commonly specifies -20 °C for routine storage, with -80 °C used for material intended to be archived for years.
Regulatory status differs sharply by region. Selank holds a Russian marketing authorization, where it is supplied mainly as nasal drops, while authorities elsewhere have not approved it for medical use. Material sold internationally is therefore usually labeled as a research chemical rather than a medicine. Peer-reviewed publications come predominantly from Russian laboratories, and sample sizes are generally small. Whether the compound produces comparable effects under independent, well-controlled replication remains an open question that the broader literature has not settled.
Selank is a synthetic heptapeptide developed in Russia as a structural analogue of tuftsin, a naturally occurring immunomodulatory tetrapeptide. Its sequence, Thr-Lys-Pro-Arg-Pro-Gly-Pro, keeps the tuftsin core at the N-terminus and appends a Pro-Gly-Pro tail. Researchers at the Institute of Molecular Genetics in Moscow synthesized the compound during the 1990s while searching for peptides with combined anxiolytic and immunomodulatory activity. The added tail was intended to resist enzymatic cleavage and prolong the molecule's presence in circulation.
The compound has a calculated molecular weight near 751.9 daltons and carries a net positive charge at physiological pH because of its arginine residue. It dissolves freely in water and in common aqueous buffers, and typically appears as a white or off-white lyophilized powder. The amide backbone makes the molecule susceptible to peptidases, which limits oral use and favors intranasal or parenteral routes. Nomenclature in the literature varies: the substance is also described by the sequence abbreviation TP-7 and by a Russian trade designation.
| Property | Value | Notes |
|---|---|---|
| Typical purity specification | 95 percent or higher by RP-HPLC | Area percentage of the main peak |
| Identity confirmation | Electrospray ionization mass spectrometry | Observed mass compared with the theoretical value near 751.9 Da |
| Recommended dry storage | -20 °C, desiccated | -80 °C for multi-year archival material |
| Solution handling | Prepare fresh; avoid long storage | Sterile filtration reduces microbial load |
| Common synonyms | TKPRPGP; TP-7 | Sequence code and laboratory designation used interchangeably |
Selank is not a naturally occurring peptide and has no known endogenous counterpart in human physiology. Russian-language sources frequently call it TP-7, while English-language sources use the name Selank almost exclusively. Database indexing is uneven, partly because early reports appeared in regional journals that are not widely cataloged. Some summaries describe the material as a tuftsin analog and others as a synthetic heptapeptide; the labels overlap rather than conflict. Citing the primary sequence resolves ambiguity more reliably than the research or trade name alone.
Selank is a synthetic heptapeptide with the sequence Thr-Lys-Pro-Arg-Pro-Gly-Pro, written TKPRPGP in one-letter notation. Its structure consists of the immunomodulatory tetrapeptide tuftsin, Thr-Lys-Pro-Arg, extended at the carboxyl terminus by a Pro-Gly-Pro segment. The molecular formula is commonly given as C33H57N11O9, corresponding to a monoisotopic mass near 751.4 Da and an average molecular mass near 751.9 Da. All seven residues are proteinogenic amino acids, and the molecule carries no modified side chains or non-natural linkages.
Naming for this compound is not fully standardised in English sources. The spelling Selanc appears in some transliterations, and catalogue entries may instead list the peptide sequence itself as the identifier. Reference material sometimes groups it with other short synthetic peptides studied for behavioural effects, which can create confusion when citations are compared. Distinguishing the exact sequence from related tuftsin analogues is therefore a practical first step when reviewing any dataset or specification sheet.
Selank is a synthetic heptapeptide with the sequence Thr-Lys-Pro-Arg-Pro-Gly-Pro, frequently abbreviated as TKPRPGP. It was designed as a structural analogue of tuftsin, a naturally occurring tetrapeptide released by enzymatic cleavage of the immunoglobulin heavy chain. The two additional proline residues at the C-terminal end extend the parent chain and change how the molecule behaves in solution. The free peptide has a calculated molecular mass of approximately 751.9 g/mol and is generally supplied as a lyophilised white to off-white powder.
Development work on the compound began in the 1980s and 1990s at the Institute of Molecular Genetics in Moscow, within the same research programme that produced the peptide Semax. Early investigators sought a tuftsin derivative with improved resistance to enzymatic breakdown and with activity in the central nervous system after peripheral administration. Most of the primary literature from this period was published in Russian, a factor that still shapes how easily the findings can be checked by outside groups.
Lyophilized Selank, the dry powder form, is generally stored frozen at minus 20 degrees Celsius or colder for long-term keeping. The solid is hygroscopic and should stay sealed, dry, and protected from light. Once dissolved, the peptide is less stable and is usually held refrigerated at 2 to 8 degrees Celsius for short periods. Repeated freezing and thawing is avoided because it can promote aggregation and loss of activity. Buffers and pH choice also affect how long a solution remains usable.
Solubility behavior is a practical concern for handling. Selank dissolves readily in water and in common aqueous buffers, which simplifies preparation of working solutions. The choice of solvent, ionic strength, and pH can influence aggregation over time, particularly at higher concentrations. Aqueous solutions are typically sterile-filtered before use. Because stability depends on several variables, storage and handling notes should be treated as general guidance rather than fixed rules, and specific values are best confirmed against a certificate of analysis for each batch.
Characterization of Selank in a laboratory setting relies on standard peptide methods. Reverse-phase high-performance liquid chromatography separates the target from related impurities and provides a purity figure, commonly reported as 95 percent or higher. Mass spectrometry, typically electrospray ionization or matrix-assisted laser desorption, confirms the molecular mass and helps detect truncation or modification. Amino acid analysis can verify composition when a sequence-level check is needed. These techniques together establish identity and purity for a given lot.
=== Sensitivity === Because the intensity of nuclear magnetic resonance signals and, hence, the sensitivity of the technique depends on the strength of the magnetic field, the technique has also advanced over the decades with the development of more powerful magnets. Advances made in audio-visual technology have also improved the signal-generation and processing capabilities of newer instruments. As noted above, the sensitivity of nuclear magnetic resonance signals is also dependent on the presence of a magnetically susceptible nuclide and, therefore, either on the natural abundance of such nuclides or on the ability of the experimentalist to artificially enrich the molecules, under study, with such nuclides. The most abundant naturally occurring isotopes of hydrogen and phosphorus (for example) are both magnetically susceptible and readily useful for nuclear magnetic resonance spectroscopy. In contrast, carbon and nitrogen have useful isotopes but which occur only in very low natural abundance. Other limitations on sensitivity arise from the quantum-mechanical nature of the phenomenon. For quantum states separated by energy equivalent to radio frequencies, thermal energy from the environment causes the populations of the states to be close to equal. Since incoming radiation is equally likely to cause stimulated emission (a transition from the upper to the lower state) as absorption, the NMR effect depends on an excess of nuclei in the lower states. Several factors can reduce sensitivity, including:
Once the cell has received a non-trivial load, and has expended the phosphocreatine reserve, a small quantity of ATP will become discharged down to AMP. AMP will instantly up-regulate myophosphorylase, which will start liberating glucose from glycogen and make it available to the glycolytic pathway, producing pyruvate and recharging AMP back to ATP. Due to the greater availability of pyruvate as a substrate, and pyruvate also contributing a citric acid cycle intermediate, α-ketoglutarate, while consuming glutamate, the citric acid cycle will also speed up. The combination of glycolysis and the citric acid cycle now balances ATP production with ATP demand and the pool of AMP does not grow further. Because all pyruvate is not burned down in the citric acid cycle—a consequence of the pyruvate's concentration regulating its burning at this moment—the excess is converted to lactate and passed into blood as lactic acid. In muscle cells with normal AMPD activity, the purine nucleotide cycle would now start to gradually add fumarate to the pool of the citric acid cycle intermediates. This would decrease the excess rate of pyruvate production by increasing its consumption, increase the rate of AMP recharge to ATP by the citric acid cycle, and consequently reduce liberation of glucose from glycogen, until increased supply of blood-borne fuels allows to shut down glycogenolysis completely. In muscle cells with AMPD deficiency, ATP production rate of the citric acid cycle will not be synchronized with ATP demand.
=== Heavy-metal contamination === Boletus edulis is known to be able to tolerate and even thrive on soil that is contaminated with toxic heavy metals, such as soil that might be found near metal smelters. The mushroom's resistance to heavy-metal toxicity is conferred by a biochemical called a phytochelatin—an oligopeptide whose production is induced after exposure to metal.
Quantum dots have been gaining interest from the scientific community because of their interesting optical properties, the main being band gap tunability. When an electron is excited to the conduction band, it leaves behind a vacancy in the valence band called hole. These two opposite charges are bound by Coulombic interactions in what is called an exciton and their spatial separation is defined by the exciton Bohr radius. In a nanostructure of comparable size to the exciton Bohr radius, the exciton is physically confined within the semiconductor resulting in an increase of the band gap of the material. This dependence can be predicted using the Brus model.
=== Afonso Dias === In one of the Dias' hearings, it was brought up that the defendant came from a poor family, was 22 and played with an 11 year old child at the time of the disappearance. It was also brought up that the defendant was meeting up with Mendonça in private as Mendonça's parents had forbidden it, after Dias came back changed from the army and as a deserter. Manuel Mendonça said that he and the neighbors noticed that Dias' financial resources increased after the boy's disappearance and that the first PJ team did not believe the information received from both the prostitute and the family. Dias was an unhygienic person, however in the day of the disappearance he took two baths. When Manuel Mendonça got to the PJ they said it was not possible to extract anything from the suspect's clothes. Manuel Mendonça also said that Dias laughed while talking to Filomena Teixeira. He also said that the defendant's lawyer and family did not want to help to find Mendonça. The chief-inspector Henrique Noronha said in 2011 that in the reconstitution there was "a hiatus of time that we couldn't figure out (...) We were a bit perplexed [when Afonso Dias said that he] stood in a place looking at nothing and burning the midnight". The inspector also said that he did not understand the reason of not following the lead of Alcina Dias. Hélder Silva, that was one of the five children that saw Mendonça for the last time, told the Correio da Manhã that Dias "Was very weird. Afonso knew Rui Pedro's whole life, where he was, who he was with, what he would do the next day.
Sources: en.wikipedia.org
Economically important iron deposits include: Carajás Mine in the state of Pará, Brazil, is thought to be the largest iron deposit in the world. El Mutún in Bolivia, where 10% of the world's accessible iron ore is located. Hamersley Basin is the largest iron ore deposit in Australia. Kiirunavaara in Sweden, where one of the world's largest deposits of iron ore is located. The Mesabi Iron Range is the chief iron ore mining district in the United States. Iron and steel industry Iron cycle Iron nanoparticle Iron–platinum nanoparticle Iron fertilization – proposed fertilization of oceans to stimulate phytoplankton growth Iron-oxidizing bacteria List of countries by iron production Pelletising – process of creation of iron ore pellets Rustproof iron Steel
No Heat Applying heat to the injured area can cause blood flow and swelling to increase. No Alcohol Alcohol can inhibit the ability to feel if the injury is becoming more aggravated, as well as increasing blood flow and swelling. No Re-injury Avoid any activities that could aggravate the injury and cause further damage. No Massage Massaging an injured area can promote blood flow and swelling, and potentially cause more damage if done too early.
== Signs and symptoms == The early clinical features of MCTD are nonspecific and may include fatigue, low-grade fever, myalgias, Raynaud phenomenon, swelling of the fingers or hands, arthralgia, esophageal reflux or dysmotility, acrosclerosis (also known as sclerodactyly), mild myositis, and various forms of pulmonary involvement. MCTD can affect nearly any organ system.
=== Double bond position === Each cannabinoid may exist in different forms depending on the double bond position in the alicyclic carbon ring. Under the dibenzopyran numbering system, the major form of THC is Δ9-THC, and the minor form is Δ8-THC. In the alternate terpene numbering system, these are Δ1-THC and Δ6-THC, respectively.
This article incorporates text from a free content work. Licensed under CC BY-SA IGO 3.0 (license statement/permission). Text taken from World Food and Agriculture – Statistical Yearbook 2023, FAO, FAO.
Sources: en.wikipedia.org
Sealed, desiccated storage at -20 °C or colder is the standard recommendation for research-grade material. Vials should reach room temperature before they are opened, which limits condensation. Repeated temperature cycling is discouraged.
A reported purity value reflects the share of the main peak in one chromatographic run and says nothing about identity. Confirming that the expected sequence is present requires a separate measurement such as mass spectrometry. Purity and identity are distinct questions.
A mass spectrum reports the molecular masses present in a sample and shows whether they match the value expected for selank, near 751.9 Da. It also flags common artifacts such as truncation or adduct formation. It does not establish correct stereochemistry or complete sequence order on its own.
Selank is a synthetic seven-amino-acid peptide modeled on tuftsin, a fragment of the immunoglobulin G heavy chain. It was designed in Russia to combine anxiolytic and immunomodulatory properties in one molecule.